DKF-25 Electric Air Control Valve Eliminating Siphonage for Self-Priming Pump

When a self-priming water pump cuts out, the party is just starting inside your pipes—and not in a good way. The inlet line and the pump casing turn into a sealed vacuum trap, triggering the Siphon Effect. This doesn’t just drain your pump; it sets off a chain reaction of water hammer, contaminated water sources, and imploded pipes.

I. Killing the Water Hammer

The Risk: The millisecond your pump stops, siphon pull makes the water scream backward. This reversal slams into the impeller and pipe joints, causing hairline cracks and leaky welds.

The Solution (DKF-25): The valve pops open the millisecond power cuts, dumping air into the system. This air acts like a hydraulic “pillow,” softening the blow and letting the backflow settle without the violent shockwave. It catches the siphon before the velocity gets out of control.

II. Stopping the “Dirty Backflow” Nightmare

The Risk: In wastewater systems, a siphon is a compliance disaster. Dirty medium can crawl back up the inlet and dump directly into your clean water source.

Double-Lock Defense:

1. Vacuum Break: Air injection kills the siphon’s “suction power” immediately.
2. Mechanical Seal: The valve’s internal seat is built to hold tight, acting as a secondary barrier so your source tank stays clean.

III. Preventing “Crushed Pipe” Syndrome

The Risk: Long, thin-walled inlet pipes can implode when the internal vacuum is too strong. Replacing collapsed large-diameter pipes is a costly, labor-intensive nightmare.

The Solution: The DKF-25 is your safety vent. By letting outside air in, it keeps the internal and external pressures balanced. Its intake is optimized to handle various pipe diameters, ensuring the pipe stays round and intact.

IV. Smart Synergy: The Prime Keeper

You might think “if it lets air in, I’ll lose my prime.” That’s where the DKF-25 gets clever. Once it has killed the siphon, the valve shuts to trap the “priming liquid” inside the pump casing. When it’s time to go again, you don’t need to refill the pump—it’s already ready for an instant start.

V. Field Maintenance: The Rule of Three

The Bottom Line: If your self-priming pump is currently running without a specialized anti-siphon valve, you’re just waiting for a water hammer or a collapsed pipe to ruin your day. The DKF-25 is the safety line that keeps your maintenance costs down and your pump up.

E-mail: sales@yoyik.com
Tel: +86-838-2226655
Whatsapp: +86-13618105229

Yoyik offers various types of power plants spare parts for steam turbines, generators, boilers as below:
Hydro Accumulator Nxq-A-6.3/31.5-L-Y
Check Valve H44W-10P
Gear Pump 2P82 6D G28Pi-V-Vs40
Check Valve H44H-600Lb
Bellows Valves Wj41F-16P
Mechanical Seal Hsg120X4-42
Safety Valve A48Y-160
Gear Pump Pfg-327-D-Ro
Globe Valve Wj65F-16
Electric Gate Valve Z960Y-P55140I
Moog Servo Valve G631-3800B
Block Valve Sd61H-P57.452V Sa-182 F91
Electric Stop Valve J961Y-P55140V
Throttle Valve L41H-100
Stop Valve J65Y-P6160V
Vacuum Butterfly Valve Dkd341H-10C
Swing Check Valve H61Y-100
Gate Z61H-100
Stop Valve J11W-16P
Reheat Hot Forging Plug Valve Sd61H-P57.462V Sa-182 F91
Butterfly Valve D343H-10C
Stop Valve J61Y-320 Sa-105
Gate Z61Y-64
Stop Valve J61Y-P55190P
Pneumatic Vacuum Trap Jt661Ys-100
Vacuum Stop Valve Dkj61H-63
Pump 100Ay67X7
Three-Way Valve J21W-64P
Spacer,Pressure Cfh3.5-1
Parallel Gate Valve Z64H-600Lb
Check Valve H64Y-64
Proportional Valve S15Fofa4Vbln
Mechanical Trip Solenoid Valve D125-413000
Superheater Safety Valve A68Y-P54110V
Servovalve Hydraulic G771K208